LS1 Lid on a LT1 Using Stock Camaro Hood
You have to lay the radiator back almost until the upper radiator hose touches the ABS mounting plate (1/4 inch gap). Pull the condenser out of it’s holding tabs and drop down. Tap down the top of the condenser. Bend the upper condenser hose to fit. Trim the radiator top. Trim the upper radiator support to fit your particular size air filter. Make some new holding straps/and or make a new cover. Cut the cross brace in the hood, just above where the Air intake will sit.
This write up was done for a 93-97 camaro. I am uncertain if a 93-97 firebird will be the same.
The Procedure
